Hét online platform voor AV verhuurbedrijven
Meyer Sound MICA
- Depth : 451.61 mm
- Enclosure : Multi-ply hardwood
- Finish : Black textured
- Frequency Response : 75 Hz - 17 kHz ±4 dB
- Height : 339.60 mm
- Impedance : 10000 ohm
- Input Impedance : 10 kohms differential between pins 2 and 3
- Width : 1051.56 mm
- Input Level : Audio source must be capable of producing a minimum of +20 dBV (10 V rms 14 V pk) into 600 Ohms inorder to produce maximum peak SPL over the operating bandwidth of the loudspeaker
- AC Voltage : 264 Volts
- Audio Input Type : Differential electronically balanced
- Wiring : Pin 1: Chassis/earth through 220 k Ohms 1000 pF 15 V clamp network to provide virtual ground lift at audiofrequencies Pin 2: Signal + Pin 3: Signal - Case: Earth ground and chassis
- CMRR : >50 dB typically 80 dB (50 Hz - 500 Hz)
- Signal to Noise : >110 dB
- Phase Response : 1 Hz - 16 kHz ±45 Degree
- DC Voltage : 6000 Volts
- Overall Length : Female XLR input with male XLR loop outputor VEAM all-in-one connector (integrates AC audio and network)
- AC Power Connector : 250 V AC NEMA L6-20 (twistlock) inlet or IEC 309 male inlet or VEAM
- Maximum SPL (Sound Pressure Level) : 138 dB
- Vertical Coverage : Varies depending on array length and configuration
- Maximum Common Mode Range : ±15 V DC clamped to earth for voltage transient protection
- DC Blocking : None on input DC blocked through signal processing
- RF Filter : Common mode: 425 kHz Differential mode: 142 kHz
- TIM Filter : Integral to signal processing (<80 kHz)
- Amplifier Type : Complementary Power MOSFET output stages (class AB/H)
- THD IM TIM : <.02 %
- Automatic Voltage Selection : Automatic two ranges each with high-low voltage tap (uninterrupted)
- Nominal Input Sensitivity : 0 dBV (1 V rms 1.4 V pk) continuous is typically the onset of limiting for noise and music
- Transducer - Low/Mid Frequency (front) : Two 18 Inch cone drivers with neodymium magnets Nominal impedance: 4 Ohms Voice coil size: 4 Inch Power-handling capability: 1200 W (AES)
- Transducer - Low/Mid Frequency (rear) : Two 15 Inch cone drivers Nominal impedance: 8 Ohms Voice coil size: 3 Inch Power-handling capability: 720 W (AES)
- Product Weight : 68.04 kg
- Maximum load protection : 4 Ohms front channels 8 Ohms rear channels
- Active Power : 3020 Watt
- Coverage Horizontal : 100 degrees
- Color : Black
- Construction : Powder-coated hex stamped steel
- Minimum Frequency Response (Bandwidth) : 60 Hz
- Maximum Frequency Response (Bandwidth) : 18 kHz
- Current Draw : 28.30 Amps
- Impedance (High Frequency) : 8 ohm
- Impedance (Mid Frequency) : 4 ohm
- Impedance (Low Frequency) : 4 ohm
- Power Handling (High Frequency) : 720 Watt
- Power Handling (Mid Frequency) : 1800 Watt
- Power Handling (Low Frequency) : 1800 Watt
LineArray Speaker 100°, 2x10”
| Locatie | 's-Gravenzande |
| Verhuurder | Generations Light & Sound Rental |
| Afstand | |
| Aantal beschikbaar | 16 stuk(s) |
| Prijs p/d | € 100,00 |
| In winkelwagen |
