PRODUCT FEATURES
Components:
LF: 1 x 10” (25 cm) 8 Ohm driver
HF: 1 x 1” throat driver + Low Distortion, Constant Directivity Asymmetrical Dispersion Horn.
Height x Width x Depth: 515 x 316 x 277 mm
Weight: 15 kg (33 lbs)
Connectors: 2 x NL4MP SPEAKON 4 pole
Construction
Baltic Birch Ply finished with textured, polyurethane black coating
Fittings:
- Handles 2, integral to cabinet
- Front finish Acoustic foam on perforated steel grille (77% transparent)
- Flying Points & 1 steel anchor point for flying track on top (6 positions)
- Fixed Installation 2 steel anchor plates for flying track on bottom (1 position)
- Stand fittings Built in Stand Fitting, 35mm (1”3/8)
SYSTEM SPECIFICATIONS
PS10 with PS10 TDController
Frequency Response [a] 65 Hz - 20 kHz ± 3dB (40 Hz - 20 kHz ±3dB with LS500 Subwoofer)
Usable Range @-6dB [a] 58 Hz - 21 kHz (38 Hz - 21 kHz with LS500 Subwoofer)
Sensitivity 1W @ 1m [b] 98 dB SPL Nominal - 96 dB SPL Wideband
Nominal Peak SPL @ 1m [b] 124 to 127dB Peak (for 200 to 500 W RMS Amp.)
HF Dispersion [c] 50° to 100° Hor. x 55° Vert. Rotatable Horn, 4 positions
Directivity : Q & DI [c] Q : 16 Nominal DI : 12 dB Nominal ( f > 3 kHz )
Crossover Frequencies 2 kHz Passive
Nominal Impedance 8 Ohms
Recommended Amplifiers 200 to 500 W atts into 8 Ohms for 1 x PS10; 400 to 1000 Watts into 4 Ohms for 2 x PS10 per channel
SYSTEM OPERATION
Electronic Controller
The PS10 Loudspeaker must be used with a Nexo Controller (PS10 TD analogue, NX241 digital or PS10AMP integrated power amplifier). Use without a properly connected Controller will result in poor sound quality and may damage the components.
Dispersion configuration
After removing the quick-release front grille, the HF Horn can be rotated to one of 4 positions for dispersion configuration.
Subbass
The PS10 Loudspeaker can be used with or without the optional LS500 Subwoofer. Active two-way operation with the LS500 is included in the PS10TD, NX241 or PS10AMP. One LS500 matches 2 x PS10, additional LS500 may be used for enhanced effect.
Speaker Cables
The PS10 is wired 2- & 2+ on Speakon connectors, LS500 on 1- & 1+. Loop through Speakons are present on both products. Single identical cables can thus be used to loop through combinations of up to 2 x PS10 & 1 x LS500 in no particular order.