Recommended for general sound reinforcement applications
Wide dynamic range and frequency response for accurate sound reproduction across the audio spectrum
Balanced transformerless output for increased immunity to noise over long cable runs
Shock mount that provides over 20dB isolation from surface vibration noise
Locking flange mount for permanently securing microphone to lecterns pulpits or conference tables
Snap-fit foam windscreen
Attached XLR preamp
Impedance : 150 ohm
Maximum SPL : 124.20 dB (1 kHz at 1% THD 1k ohms load) All settings +6dB at 0 gain
Output Impedance : 180 ohms actual (rated at 150 ohms) at 1000Hz
Polar Pattern : Cardioid
Power Requirements : 11 to 52V DC phantom 2mA
Sensitivity : -35 dB
Regulatory Compliance : CE
Certification : Eligible to bear CE Marking Conforms to European EMC Directive 89/336/EEC Meets applicable tests and performance criteria in European Standard EN55103 (1996) parts 1 and 2 for residential (E1) and light industrial (E2) environments
Relative Humidity : 0 to 95 %
Polarity : Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output connector
Open Circuit Sensitivity : â??35dB (17.8mV) (at 1kHz ref. 1 V/Pascal) All settings â??12dB at 0 gain 1 Pascal = 94dB SPL
Signal to Noise : 66 dB (referenced at 94dB SPL)
Common Mode Rejection : 45 dB (minimum)
Equivalent Output Noise : 28 dB SPL (A-weighted)
Preamplifier Output Clipping Level : â??6dBV (0.5V) â??12dB at 0 gain (1% THD)
Pickup Angle : 130 degree (â??3dB)
DC Voltage : 52 Volts
Maximum SPL (Sound Pressure Level) : 124.20 dB
Minimum Frequency Response (Bandwidth) : 50 Hz
Minimum Frequency Response (Bandwidth) : 0.05 kHz
Maximum Frequency Response (Bandwidth) : 17000 Hz
Maximum Frequency Response (Bandwidth) : 17 kHz
Dynamic Range : 96.20 dB
Signal to Noise Ratio : 66 dB
Operating Temperature (Maximum) : 57 C
Operating Temperature (Minimum) : -18 C
Dynamic Range at 1k ohms Load : 96.2 dB 100dB at 0 gain