Rent Around

Supply Voltage/Frequency: 194 - 264V, 48 - 62Hz. Main power connector should be 60A or greater (single phase), 20A or greater(three phase). Recommended connector type: CEE 17 BS4343.
Total Capacity: Maximum load 20A per dimmer - total 60A. Minimum load 250W per dimmer.
Control: Analogue auto-sensing 0V to -10V (full-on) via 10k? resistor and
silicon diode, or 0V to +10V (full-on) via 1K resistor and silicon
diode.
Dimmer Test Switches: Switch any dimmer to a preset level.
Power Supply Output: -14.5V DC (Max current 100mA) via analogue control input connector.
Connections: Mains input cable can be inserted through a 25mm or 32mm cable entry hole in the rear panel or a 32mm hole on the left hand side, using a suitable cable gland. Load connections are made through a CEE17 32A plug.
Circuit Protection: Each dimmer module is protected by a 25A circuit breaker
Control Input: Analogue 0V to 10V (+/-), via 8 pin locking DIN connector on front panel. DMX512 multiplexed digital control, and Strand D54 multiplexed analogue control via 3 pin XLR connector, both on Multi-mux module faceplate.
Output: Max 5KW per dimmer, rated for continuous loads
Ambient Temp Operating Range: 0°C - 35°C
Relative Humidity Operating Range: 10% - 95%, zero condensation.

Environment/Ventilation: Clean, dry ventilated space within temperature and humidity limitations.
Standards Compliance: BS800. VDE 0875, EN55014, EN50081-1, EN50082-1
Ingress Protection: IP 20 (IEC529/EN60529).

Verhuurder	Afstand	Prijs
Kugel Licht & Geluid B.V.	Apeldoorn	€ 27,50 1 stuk(s)	In winkelwagen Meer informate
Lichtpunt	Groningen	€ 30,00 2 stuk(s)	In winkelwagen Meer informate

Strand Act 3 3x 5kw dimmer