- Supply Voltage/Frequency: 194 - 264V, 48 - 62Hz. Main power connector should be 60A or greater (single phase), 20A or greater(three phase). Recommended connector type: CEE 17 BS4343.
- Total Capacity: Maximum load 20A per dimmer - total 60A. Minimum load 250W per dimmer.
- Control: Analogue auto-sensing 0V to -10V (full-on) via 10k? resistor and
- silicon diode, or 0V to +10V (full-on) via 1K resistor and silicon
- diode.
- Dimmer Test Switches: Switch any dimmer to a preset level.
- Power Supply Output: -14.5V DC (Max current 100mA) via analogue control input connector.
- Connections: Mains input cable can be inserted through a 25mm or 32mm cable entry hole in the rear panel or a 32mm hole on the left hand side, using a suitable cable gland. Load connections are made through a CEE17 32A plug.
- Circuit Protection: Each dimmer module is protected by a 25A circuit breaker
- Control Input: Analogue 0V to 10V (+/-), via 8 pin locking DIN connector on front panel. DMX512 multiplexed digital control, and Strand D54 multiplexed analogue control via 3 pin XLR connector, both on Multi-mux module faceplate.
- Output: Max 5KW per dimmer, rated for continuous loads
- Ambient Temp Operating Range: 0°C - 35°C
- Relative Humidity Operating Range: 10% - 95%, zero condensation.
- Environment/Ventilation: Clean, dry ventilated space within temperature and humidity limitations.
- Standards Compliance: BS800. VDE 0875, EN55014, EN50081-1, EN50082-1
- Ingress Protection: IP 20 (IEC529/EN60529).
Strand Act 3, 3 x 5000W Dimmer
Locatie |
Groningen |
Verhuurder |
Lichtpunt |
Afstand |
|
Aantal beschikbaar |
2 stuk(s) |
Prijs p/d |
€ 30,00 |
|
In winkelwagen
|