Hét online platform voor AV verhuurbedrijven
Crown Xs700
Minimum Guarenteed Power (120 VAC, 60Hz Units, per channel, both channels driven 1 kHz with 0.15% THD)
Performance
Controls
Input/Output
Construction
- 2 Ohm: 900W
- 4 Ohm: 650W
- 8 Ohm: 450W
- 4 Ohm (bridge): 1900W
- 8 Ohm (bridge): 1645W
Performance
- Sensitivity (volts RMS) for full rated power at 4 ohms: 1.4V
- Frequency Response (at 1 watt): 22 Hz to 22 kHz: 1 dB.
- Phase Response (degrees at 1 watt, 20 Hz to 20 kHz): +5, 18
- Signal-to-Noise Ratio: A-weighted, below rated power: > 102 dB.22Hz to 22kHz, below rated power: > 97 dB.
- Total Harmonic Distortion (THD) at full bandwidth power, from 20 Hz to 20 kHz: 0.5%.
- Intermodulation Distortion (IMD): (60 Hz and 7 kHz at 4:1) from full rated output to 40 dB: < 1%.
- Damping Factor (8 ohm) 10 Hz to 400 Hz: > 200.
- Crosstalk (below rated power):(1 kHz, 20 kHz): > 55 dB, > 55 dB
- Voltage Gain (at maximum level setting): 38:1 (31.6 dB)
- Load Impedance: Safe with all types of loads.Xs500, 700, 900, 1200: 2 to 8 ohms in Stereo, 4 to 8 ohms in Bridge Mono.Xs4300: 4 to 8 ohms in Stereo, 8 ohms in Bridge Mono.
- AC Line Voltage and Frequency Configurations Available (10%): 120VAC/60 Hz and 230VAC/50 Hz.
Controls
- Level: Two or four front-panel, gray rotary level controls, one for each channel.
- Power: Front-panel switch; on when in the right-hand position.
- Signal: Two or four green LEDs, one for each channel, illuminates when the channels input signal level is above 40 dBu.
- Clip: Two or four front-panel red LEDs, one for each channel, illuminates when the channels output signal is being overdriven.
- Power: Yellow front-panel LED indicates amplifier has been turned on and AC power is available.
- AC Mains: Red front-panel LED indicates the presence of AC power at the power cord, even if the amplifier is not turned on.
- Fault: Red front-panel LED illuminates when amplifier is in protect mode. Also illuminates briefly during normal power-up when amplifier is first switched on.
- Bridge: Yellow LED indicates that amplifier is in bridge mode (Channels 1 and 2, Channels 3 and 4 in Xs 4300).
- Temp: Red LED indicates that channel(s) are in thermal protect mode.
Input/Output
- Input Connectors: XLR-1/4" combo connectors: One per channel, 3-pin female XLR connector and TRS 1/4" phone jack accept balanced or unbalanced signals.
- 3-pin Phoenix-style connectors (2-channel models only): One per channel, accepts balanced or unbalanced signals.
- Input Impedance (nominal) balanced, unbalanced: 20 k ohms, 10 k ohms.
- Output Connectors: Balanced XLR connectors (2-channel models only): One per channel, 3-pin male XLR connector in parallel with XLR-1/4" combo and Phoenix-style input connectors for daisy-chain operation.5-Way binding post output connectors: One pair per channel; accept banana plugs, spade lugs or bare wire.Note: Binding post outputs on European models come with safety plugs installed to prevent European power-cord plugs from being inserted. The top & bottom entry positions for these connectors should therefore be used with European models.4-Pole Speakon output connector (2-channel models only): One connector per channel. Accepts a 4-pole Speakon connector.
- DC Output Offset (shorted input): < 75 millivolts.
- Output Signal: Stereo, unbalanced, two-channel or four-channel (Xs4300 only)
- Xs Series amplifiers provide extensive protection and diagnostic capabilities, including output current limiting, microprocessor-controlled DC protection, circuit breaker, and special thermal protection for the units transformers.
Construction
- Ventilation: Flow-through ventilation from front to back.
- Cooling: Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation.
- Air Volume Requirements (per minute per unit): 80.15 ft (2.27 m).
- Dimensions: EIA Standard 19-inch (48.3-cm) rack mount width (EIA RS-310-B), 3.5-inch (8.9-cm) height and 17.14-inch (43.5-cm) depth behind the mounting surface.
- Weight: 13.1 kg
The Xs Series of power amplifiers from Crown® represents a new era in affordable, quality power amplification. The line consists of four models, each in a uniform, rugged chassis. The Xs Series incorporates the best of tried-and- true design principles and innovative features.
Modern power amplifiers are sophisticated pieces of engineering capable of producing extremely high power levels. They must be treated with respect and correctly installed if they are to provide the many years of reliable service for which they were designed.
In addition, Xs Series amplifiers include a number of features which require some expla- nation before they can be used to their maxi- mum advantage.
| Locatie | Medemblik |
| Verhuurder | P-S-L Licht en geluid techniek |
| Afstand | |
| Aantal beschikbaar | 2 stuk(s) |
| Prijs p/d | € 20,00 |
| In winkelwagen |
