Rent Around

Electronics

Direct Power Out
- 4 ohm bridge 1k Hz, 1% THD: 1800 W
- 8 ohm bridge 45-20k Hz, 0.1% THD: 1200 W
- 2 ohm Load/Channel, 1k Hz, 1% THD: 900 W
- 4 ohm Load/Channel, 45-20k Hz, 0.1% THD: 600 W
Isolated Constant Voltage Out
- 200V or 140V Bridge: 1000 W
- 100V or 70V/Channel: 500 W
- 25V/Channel: 400 W
Frequency Response: (bandlimited by built-in highpass filter)
- Direct Outputs: 45-20k Hz, -3 dB
- Isolated Outputs: 45-16k Hz, -3 dB
Sensitivity (for full output): 1.0V
Voltage Gain (direct outputs): 56 (35 dB)
Output Circuit Type: Class H complementary linear stage
Distortion: SMPTE-IM less than 0.05%
Damping Factor: Greater than 200 (direct outputs)
Noise: Less than 100 dB below rated output (20 Hz to 20 kHz)
Input Impedance: 20k ohm balanced, 10k ohm unbalanced
Amplifier Protection: Short circuit protection, open circuit, ultrasonic, RF, thermal muting, over-temperature. Stable into reactive or under-impedance loads.
Load Protection: Turn-on/turn-off muting, DC-fault load grounding relay (MPC300, 300T, 600, 600T) with internal fault fuses.
Power Requirements: 100V, 120V, 220V or 230V AC, 50 - 60 Hz (Not user configurable)

Physical

Controls:
- Front Panel: Power Switch
- Rear Panel: Ch1 & Ch2 level, (11 detents: 0, -2, -6, -8,. -10, -12, -14, -18, -24, off) Parallel/Stereo/Bridge switch (except MPC200 & 200T bridged on connector)
Connectors:
- Input: Euro-style detachable header with screw-down terminal for bare wires
- Output: Covered barrier strip for bare wires or spade terminal
Cooling: Two-speed fan with back-to-front airflow
Net Weight: 31 kg (67 lb)
Dimensions (H x W x D):
- 133 x 483 x 455 mm (rack depth 450 mm)
- 3 Rack Units high

JBL MPC600T