Hét online platform voor AV verhuurbedrijven
Alle afstanden
< 3 km
< 5 km
< 10 km
< 15 km
< 25 km
< 50 km
< 75 km
Zoek
Rent Around gaat veranderen!
Home
Support
Inloggen
Registreren
Contact
IT
Geluid
Communicatie
Kabels
Licht
Sets
Rigging
Special FX
Video
Conference
Diversen
Decor & Stage
Alle afstanden
< 3 km
< 5 km
< 10 km
< 15 km
< 25 km
< 50 km
< 75 km
Zoek
Home
/
Geluid
/
Randapparatuur
/
Luidspreker Management / DSP
/
Apex Intelli-X3 648
Apex Intelli-X3 648
Specificaties
Verhuurderinformatie
Balanced line level inputs
Connectors: 3-pin XLR (software switch-able between analog and AES-3)
Type: electronically balanced
Impedance: >10k ohms, balanced
Common mode rejection: >90dB
Max input level: 21, 24 dBu software selectable, balanced, 1% THD+N
Frequency response: 20 Hz – 20 kHz, ±0.3 dB
THD+N: less than 0,0055%, +4 dBu, 20Hz- 20 kHz, 22 kHz BW
Dynamic range: 120 dB, 20 Hz to 20kHz, un-weighted at +21dBu headroom settings
Crosstalk: >90 dB
AD conversion: 24-bit, sigma-delta
AES-3 inputs
Connector: 3-pin XLR (software switch-able between analog and AES-3)
Type: transformer isolated
Impedance: 110 ohms balanced
Supported formats: AES-3 up to 24-bit
Supported sample rates: 32 to 192 kHz
Dante Audio over IP
Connector: 2x Neutrik ethercon (seperate from control network)
Connection: 2x 1Gb
Redundancy: Yes (switched or Redundant Pri/Sec modes)
Input / output channel: 4 sources x 8 sinks
Audio Clocking
Clock sources master: Internal low jitter clock
Clock sources slave: Dante PTP clock, AES A/B, AES C/D
Network remote control
Built-in Ethernet switch: IEEE 802.3 10Base-T/100Base-TX
Connectors: 3 x Neutrik EtherCon, Auto MDI-MDIX
Protocol: Proprietary UDP/IP based, SNMP
Input channels functions
Gain: -80 to +15dB, 0,1dB steps
Polarity: normal / inverted
PEQ
Bands 12
Filter types: Bell-Symmetrical, Bell-Asymmetrical, Notch, Low-Shelving 6dB/oct, LowShelving
12dB/oct, High-Shelving 6dB/oct , High-Shelving 12dB/oct, AllPass
90°, All-Pass 180°, High-Pass 6dB/oct, High-Pass 12dB/oct, High-Pass
Vari-Q 12dB/oct, Low-Pass 6dB/oct, Low-Pass 12dB/oct, Low-Pass Vari-Q
12dB/oct, Band-Pass
Frequency: 10Hz to 22kHz, 0,1Hz steps
Gain: -40 to +15dB, 0,1dB steps (when applicable)
Q: 0,1 to 48, 0,01 steps (when applicable)
Mix matrix functions
Gain: -80 to +15dB, 0,1dB steps
Routing: enabled/disabled
Driver alignment:
Duration: 0 to 30ms, sample rate depend steps,
Distance: 0 to 1029cm, 0,1cm steps (temperature and relative humidity
independent)
FIR filters:
At 48 kHz: 8 x 1024 taps or 8 x 512 taps
At 96 kHz: 3 x 1024 taps or 6 x 512 taps
Gain: -80 to +15 dB, 0,1 dB steps
Polarity: normal / inverted
Operating
Temperature: 0° to 50° C
Relative humidity: 10 to 60 %, non-condensing
Dimensions
Width: 483 mm (19-inch)
Package
Width: 590 mm
Height: 120 mm
Depth: 400 mm
Balanced line level outputs
Connector: 3-pin XLR (software switch-able between analog and AES-3)
Type: electronically balanced
Impedance: <50 ohms, balanced
Max output level: 15, 21 dBu software selectable, into 600 ohms, balanced, 1% THD+N
Frequency response: 20 Hz – 20 kHz, ±0.3 dB
THD+N: less than 0,007%, +4 dBu, 20Hz- 20 kHz, 22 kHz BW
Dynamic range: 120 dB, 20 Hz to 20kHz, un-weighted at +21dBu headroom settings
Crosstalk: >90 dB
DA conversion resolution: 24-bit
AES-3 outputs
Connector: 3-pin XLR (software switch-able between analog and AES-3)
Type: transformer isolated
Impedance: 110 ohms, balanced
Word-clock input
Connector: BNC
Termination: 75 ohms switch-able
Input level: 1 to 10 Vpp
Digital processing
Sample rate: 44,1kHz, 48kHz, 88,2kHz, 96kHz, 176,4kHz or 192kHz selectable
Internal processing: Dual 32-bit floating point processors
Input / output channel: 4 in x 8 out
Mains
Connector: Neutrik PowerCon
Voltage: Auto-detect 100-240 Vac (+/- 10 %) – 50-60 Hz
Power consumption: < 60 VA
Delay
Duration: 0 to 1500ms, sample rate depend steps,
Distance: 0 to 500m
Temperature: -20 to 50°C (-4 to 122°F), 0,1° steps
Relative humidity: 0 to 100%, 0,1% steps
GEQ: 30-band ISO centred, +/-15 dB, proportional-Q or constant-Q mode selectable
Compressor
Threshold: -80 to 0dBfs, 0,1dB steps
Ratio: 1:1 to 20:1, 1 steps
Knee: hard or soft
Attack time: 0,5 to 100ms, 0,1ms steps
Release time: 5 to 5000ms, 0,1ms steps
Side-chain mode: fl at, high-pass or band-pass mode
Make-up gain: 0 to +10dB, 0,1dB steps
High-pass and low-pass crossover
Filter types: Butterworth 6 to 48dB/octave, 6dB steps
Linkwitz-Riley 12 to 48dB/octave, 12dB steps
Bessel 12 to 48dB/octave, 6dB steps
Frequency: 10Hz to 20kHz, 0,1Hz steps
Limiter
Type: Dual-stage, RMS + Peak limiter
RMS threshold: -80 to 0 dBfs (or dBu equivalent), 0,1 dB steps
Peak threshold: -80 to 0 dBfs (or dBu equivalent), 0,1 dB steps
RMS attack: 0,1 to 100 ms, 0,1 ms steps
Peak attack: 0ms
Release: 5 to 5000 ms, 0,1 ms steps
Storage
Temperature: -20° to 70° C
Mechanical specifications
Height: 43,6 mm (1,75-inch – 1U)
Depth: 286 mm
Verhuurder
Afstand
Prijs
Tweet
Rent Around
E:
info@rentaround.nl
Informatie
Rent Around gaat veranderen!
Home
Support
Inloggen
Registreren
Contact
Assortiment
IT
Geluid
Communicatie
Kabels
Licht
Sets
Rigging
Special FX
Video
Conference
Diversen
Decor & Stage
Privacy verklaring
Disclaimer
Algemene voorwaarden
Rentaround - Alle rechten voorbehouden © 2024