IT Geluid Communicatie Kabels Licht Sets Rigging Special FX Video Conference Diversen Decor & Stage

Home / Geluid / Randapparatuur / Luidspreker Management / DSP / Orban OPTIMOD 6300
In winkelwagen

Orban OPTIMOD 6300

Analog Audio Input
  • Configuration: Stereo / Dual-Mono.
  • Impedance: >10kΩ load impedance, electronically balanced. 
  • Nominal Input Level: Software adjustable from -4.0 to +13.0 dBu (VU).
  • Maximum Input Level: +27 dBu.
  • Connectors: Two XLR-type, female, EMI-suppressed. Pin 1 chassis ground, Pins 2 (+) and 3 electronically balanced, floating and symmetrical.
  • A/D Conversion: 24 bit 128x oversampled delta sigma converter with linear-phase anti-aliasing filter.
  • Filtering: RFI filtered, with high-pass filter at 0.15 Hz (-3 dB). 

Analog Audio Output
  • Configuration: Stereo / Dual-Mono.
  • Source Impedance: 50Ω, electronically balanced and floating.
  • Load Impedance: 600Ω or greater, balanced or unbalanced. Termination not required or recommended.
  • Output Level (100% peak modulation): Adjustable from -6 dBu to +24 dBu peak, into 600Ω or greater load, software-adjustable.
  • Signal-to-Noise: >= 90 dB unweighted (Bypass mode, de-emphasized, 20 Hz-15 kHz bandwidth, referenced to 100% modulation).
  • L/R Crosstalk: <= -70 dB, 20 Hz-15 kHz.
  • Distortion: <= 0.01% THD (Bypass mode, de-emphasized) 20 Hz-15 kHz bandwidth.
  • Connectors: Two XLR-type, male, EMI-suppressed. Pin 1 chassis ground, Pins 2 (+) and 3 electronically balanced, floating and symmetrical.
  • D/A Conversion: 24 bit 128x oversampled.
  • Filtering: RFI filtered. 

Digital Audio Input
  • Configuration: Stereo or Two-Channel (dual-mono) per AES3 standard, 24 bit resolution, software selection of stereo or dual-mono. Unit can detect Stereo or Two-Channel status bits and switch modes appropriately.
  • Sampling Rate: 32, 44.1, 48, 88.2, or 96 kHz, automatically selected.
  • Connector: XLR-type, female, EMI-suppressed. Pin 1 chassis ground, pins 2 and 3 transformer balanced and floating, 110Ω impedance.
  • Input Reference Level: Variable within the range of -30 dBFS to -10 dBFS.
  • J.17 Deemphasis: Software-selectable.
  • Filtering: RFI filtered. 

Digital Audio Output
  • Configuration: Stereo or Two-Channel per AES3 standard. Output configured in software as flat or pre-emphasized to the chosen processing preemphasis (50µs or 75µs), with or without J.17 preemphasis.
  • Sample Rate: Internal free running at 32, 44.1, 48, 88.1 or 96 kHz, selected in software. Can be synced at 32, 44.1, 48, 88.1 or 96 kHz to 1x wordclock or AES11id applied to the Sync input or to AES3 or AES11 signals applied to the AES3 digital input.. (Passband is limited to approximately 14.7 kHz when using 32 kHz output sample rate.) 
  • Word Length: Software selected for 24, 20, 18, 16 or 14-bit resolution. First-order highpass noise-shaped dither can be optionally added, Dither level automatically adjusted appropriately for the word length. 
  • Connector: XLR-type, male, EMI-suppressed. Pin 1 chassis ground, pins 2 and 3 transformer balanced and floating, 110Ω impedance.
  • Output Level (100% peak modulation): -20.0 to 0.0 dBFS software controlled.
  • Filtering: RFI filtered. 

Sync Input
  • Configuration: Can accept wordclock or AES11id (75Ω) sync, selectable in software.
  • Connector: Female BNC.
  • Termination: Unterminated. For wordclock, use an external 75Ω terminator if the 6300 is the last item in the chain. For AES11id, always use a 75Ω terminator. 

Remote Computer Interface
  • Configuration: TCP/IP protocol via direct serial cable connect, modem, or Ethernet interface. Modem is not supplied. 
  • Serial Port: 115 kbps RS-232 port dB-9 male, EMI-suppressed. 
  • Ethernet Port: 100 Mbit / sec on RJ45 female connector. 

Remote Control (GPI) Interface
  • Configuration: Eight (8) inputs, opto-isolated and floating. 
  • Voltage: 6-15V AC or DC, momentary or continuous. 9VDC provided to facilitate use with contact closure.
  • Connector: DB-25 male, EMI-suppressed.
  • Control: User-programmable for any eight of user presets, factory presets, bypass, test tone, stereo or mono modes, analog input, digital input.
  • Filtering: RFI filtered. 

Power
  • Voltage: 100-264 VAC, 50-60 Hz, 40 VA.
  • Connector: IEC, EMI-suppressed. Detachable 3-wire power cord supplied.
  • Grounding: Circuit ground is independent of chassis ground, and can be isolated or connected with a rear panel switch.
  • Safety Standards: ETL listed to UL standards, CE marked. 

Environmental
  • Operating Temperature: 32º to 122º F / 0º to 50º C for all operating voltage ranges.
  • Humidity: 0-95% RH, non-condensing.
  • Dimensions (W x H x D): 19" x 1.75 " x 14.25" / 48.3 cm x 4.4 cm x 36.2 cm. 1RU.
  • Humidity: 0-95% RH, non-condensing.
  • RFI / EMI: Tested according to Cenelec procedures. FCC Part 15 Class A device.
  • Shipping Weight & Dimensions: 18 lbs / 8.2 kg - 23" x 23" x 6"
The OPTIMOD 6300 is a high-quality, multipurpose stereo audio processor for digital radio (DAB+, HD Radio), digital television, netcasts, STL protection, satellite uplink protection, and digital mastering.
Background information: What to consider when it comes to Audio Processing for DAB+/Streaming
Thanks to versatile signal routing, the 6300 can also serve as a studio AGC with an all-digital signal path, and simultaneously as a talent headphone processor.
Because all processing is performed by high-speed mathematical calculations within digital signal processing (DSP) chips, the processing has cleanliness, quality, and stability over time and temperature that is unmatched by analog processors.
Locatie Raamsdonksveer
Verhuurder RBS Showequipment
Afstand
Aantal beschikbaar 1 stuk(s)
Prijs p/d € 125,00
  In winkelwagen

Rent Around

E: info@rentaround.nl


        

Informatie

Assortiment