Acoustical
Operating Frequency Range: 25 Hz - 160 Hz
Frequency Response: 29 Hz - 135 Hz ±4 dB
Phase Response: 41 Hz - 155 Hz ±30°
Maximum Peak SPL: 127 dB
Dynamic Range
: >110 dB
Coverage
360° single unit; varies for multiple units, depending on number and configuration
Transducers
- Low Frequency
- Two 10" cone drivers
- Nominal impedance: 4Ω
- Voice coil size: 2"
- Power-handling capability: 400 W
Audio Input
- Type: Differential, electronically balanced
- Maximum Common Mode Range: ±15 V DC, clamped to earth for voltage transient protection
- Connectors: Female XLR input with male XLR loop output
- Input Impedance: 10 kΩ differential between pin 2 & 3
- Wiring
- Pin 1: Chassis/earth through 220 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
- Pin 2: Signal +
- Pin 3: Signal - (optional polarity reversal switch)
- Case: Earth ground and chassis
- DC Blocking: Differential DC blocking up to max common mode voltage
- CMRR: >50 dB, Typically 80 dB (50 Hz - 500 Hz)
- RF Filter: Common Mode: 425 kHz; Differential Mode: 142 kHz
- TIM Filter: <80 kHz, integral to signal processing
- Nominal Input Sensitivity: 0 dBV (1 V rms, 1.4 V pk) continuous is typically the onset of limiting for pink noise and music
- Input Level: Audio source must be capable of producing a minimum of +20 dBV (10 V rms, 14 V pk) into 600Ω in order to produce maximum peak SPL over the operating bandwidth of the loudspeaker
Amplifier
- Type: Two-channel complementary MOSFET output stages (class AB/bridged)
- Output Power: 450 W total
- THD, IM, TIM: <.02 %
- Load Capacity: 4Ω both channels
- Cooling: Convection
AC Power
- Connector: PowerCon with looping output
- Voltage Selection: External 115/230 V AC switch (100 V AC version available)
- Operating Voltage Ranges: 105 V AC - 130 V AC (115 V AC); 210 V AC - 260 V AC (230 V AC)
Current Draw
- Idle Current: .0.13 A rms (115 V AC); 0.065 A rms (230 V AC); 0.15 A rms (100 V AC)
- Max Long-Term Continuous Current (>10 sec): 1 A rms (115 V AC); 0.5 A rms (230 V AC); 1.2 A rms (100 V AC)
- Burst Current (<1 sec): 1.3 A rms (115 V AC); 0.65 A rms (230 V AC); 1.5 A rms (100 V AC)
- Ultimate Short-Term Peak Current Draw: 2.9 A pk (115 V AC); 2 A pk (230 V AC); 3.3 A pk (100 V AC)
- Inrush Current: 18 A pk (115 V AC); 12 A pk (230 V AC); 15 A pk (100 V AC)