Hét online platform voor AV verhuurbedrijven
Meyer Sound UPJunior
Acoustical
Transducers
- Operating Frequency Range: 70Hz–20 kHz
- Frequency Response: 76Hz–18 kHz ±4 dB
- Phase Response: 250Hz–18 kHz ±45°
- Maximum Peak SPL: 126 dB
- Dynamic Range: >110 dB
- Coverage: 80° x 50°
- Crossover: 3,5kHz
Transducers
- Low Frequency
- One 8" cone driver with neodymium magnet
- Nominal impedance: 4Ω
- Voice coil size: 1.5"
- Power-handling capability: 300 W (AES
- High Frequency
- One 2" compression driver
- Nominal impedance: 12Ω
- Voice coil size: 2"
- Diaphragm size: 2"
- Exit size: 0.75"
- Power-handling capability: 100 W
- Type: Differential, electronically balanced
- Maximum Common Mode Range: ±15 V DC, clamped to earth for voltage transient protection
- Connectors: Female XLR input with male XLR loop output
- Input Impedance: 10 kΩ differential between pins 2 and 3
- Wiring
- Pin 1: Chassis/earth through 220 kΩ, 1000 pF, 15 V clamp network to provide virtual ground lift at audio frequencies
- Pin 2: Signal +
- Pin 3: Signal - (optional polarity reversal switch)
- Case: Earth ground and chassis
- DC Blocking: Differential DC blocking up to maximum common mode voltage
- CMRR: >50 dB, typically 80 dB (50–500 Hz)
- RF Filter: Common mode: 425 kHz; Differential mode: 142 kHz
- TIM Filter: <80 kHz, integral to signal processing
- Nominal Input Sensitivity: 0 dBV (1 V rms, 1.4 V peak) continuous average is typically the onset of limiting for noise and music
- Input Level: Audio source must be capable of producing +20 dBV (10 V rms, 14 V peak) into 600Ω to produce maximum peak SPL over the operating bandwidth of the loudspeaker
- Type: Two-channel complementary MOSFET output stages (class AB/bridged)
- Output Power: 300 W total
- THD, IM, TIM: <.02%
- Load Capacity: 4Ω low channel, 12Ω high channel
- Cooling: Forced air cooling over amplifier heatsink
- Connectors: PowerCon with looping output
- Voltage Selection: Automatic
- Safety Agency Rated Operating Range: 100–240 V AC; 50/60 Hz
- Turn-on and Turn-off Points: 90–264 V AC; 50/60 Hz
- Current Draw:
- Idle Current: 0.448 A rms (115 V AC); 0.285 A rms (230 V AC); 0.497 A rms (100 V AC)
- Maximum Long-Term Continuous Current (>10 sec): 2.55 A rms (115 V AC); 1.55 A rms (230 V AC); 2.75 A rms (100 V AC)
- Burst Current (<1 sec): 2.90 A rms (115 V AC); 1.70 A rms (230 V AC); 3.20 A rms (100 V AC)
- Ultimate Short-Term Current: 12.0 A peak (115 V AC); 9.0 A peak (230 V AC); 13.0 A peak (100 V AC)
- Inrush Current: 15.0 A peak (115 V AC); 13.0 A peak (230 V AC); 15.0 A peak (100 V AC)
| Locatie | GRONINGEN |
| Verhuurder | Bano |
| Afstand | |
| Aantal beschikbaar | 8 stuk(s) |
| Prijs p/d | € 45,00 |
| In winkelwagen |
