IT Geluid Communicatie Kabels Licht Sets Rigging Special FX Video Conference Diversen Decor & Stage

Extron SW4AR RGBHV

Video
   Gain  Unity.
   Bandwidth  350 MHz (-3 dB)
   Crosstalk  -70 dB @ 10 MHz
   Switching speed  5 ms (max.)
Video input
   Number/signal type   
      SW4 RGBHV 4 RGBHV, RGBS, RGsB, RsGsBs, HDTV component video, S-video, composite video (or digital audio)
   Connectors   
      SW4 RGBHV 4 x 5 female BNC
   Nominal level  1.0 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
   Minimum/maximum levels  Analog: 0.3 V to 1.5 Vp-p with no offset
   Impedance  75 ohms
   Return loss  <-30 dB @ 10 MHz
   DC offset (max. allowable)  5.0V
   Input coupling  DC
Video output
   Number/signal type  1 RGBHV, RGBS, RGsB, RsGsBs, HDTV component video, S-video, composite video (or digital audio)
   Connectors  5 female BNC
   Nominal level  1.0 Vp-p for Y of component video and S-video, and for composite video
0.7 Vp-p for RGB and for R-Y and B-Y of component video
0.3 Vp-p for C of S-video
   Minimum/maximum levels  0.5 V to 1.5 Vp-p (follows input)
   Impedance  75 ohms
   Return loss  <-30 dB @ 10 MHz
   DC offset  ±5 mV maximum with input at 0 offset
Sync
   Input type  RGBHV, RGBS, RGsB, RsGsBs, bi-level and tri-level sync
   Output type  RGBHV, RGBS, RGsB, RsGsBs, bi-level and tri-level sync
   Input level  Analog or TTL, 0.5 V to 5.0 Vp-p
   Output level  5.0 Vp-p, unterminated, for V output; H output follows input
   Input impedance  510 ohms for V input and unselected H input; the selected H input impedance is determined by the device connected to the H output.
   Output impedance  75 ohms for V output; the H output impedance is determined by the device connected to the selected H input.
   Max. input voltage  5.0 Vp-p
   Max. propagation delay  35 ns
   Max. rise/fall time  4 ns
   Polarity  Positive or negative (follows input)
Digital audio — all models' H channel
   Input type  Dolby® Digital, DTS, AES/EBU
   Output type  Dolby Digital, DTS, AES/EBU
   Bandwidth  250 MHz (-3 dB)
   Sampling rates  32, 44.1, 48, 96 kHz
   Input level  0.5 V to 5.0 Vp-p
   Output level  2.5 Vp-p (when terminated with 75 ohms)
   Input impedance  510 ohms for unselected inputs; for the selected input, impedance is determined by the device connected to the output
   Output impedance  Determined by the device connected to the selected input
   Max. input voltage  5.0 Vp-p
   Max. propagation delay  35 ns
   Max. rise/fall time  4 ns
     
 
 
Control/remote — switcher
   Serial control port  RS-232, female 9-pin D connector (same as the contact closure port)
   Baud rate and protocol  9600 baud, 8 data bits, 1 stop bit, no parity
   Serial control pin configuration  2 = TX, 3 = RX, 5 = GND
   Contact closure  1 female 9-pin D connector (same as the RS-232 port)
   Contact closure pin configuration  1 = input #1, 4 = input #2, 6 = input #3, 7 = input #4, 8 = input #5, 9 = input #6
   Program control  Extron control/configuration program for Windows®
Extron Simple Instruction Set (SIS)
 
General
   Power  100 VAC to 240 VAC, 50-60 Hz, 20 watts, internal
Locatie GRONINGEN
Verhuurder Bano
Afstand
Aantal beschikbaar 1 stuk(s)
Prijs p/d € 30,00
  In winkelwagen